Sony Ipela NSR-1100, Installation Manual

Page: 5 / 336

System Requirements
5
system software develops a malfunction, lightning-
quick restoration of the system is possible. The NSR
also supports uninterruptible power supplies (UPS),
making them extremely reliable systems.
1) RAID 5 is a system for dividing and storing data and parity
(error correcting codes) onto more than one hard disk drive.
Although this system allows continued operation should
one of the hard disks malfunction, it does not guarantee
restoration of lost data. In addition, due to high internal
processing loads during reconstruction after you replace
the malfunctioned hard disk, the unit may not be able to
record images at the configured recording rate while
reconstruction is in progress.
Other features
• You can display the images from up to 64 cameras
(8
×
8 images) on one screen.
• The NSR is capable of manual, scheduled, and alarm
recording, among others.
• The NSR is equipped with a motion detection
function
1)
(Video Motion Detection (Recorder)).
• Run searches for recorded images by camera name,
date, alarm, and other methods.
• Create privacy zones by using the dynamic masking
functions
2)
. Dynamic masking covers pan, tilt, and
zoom.
• Precise alarm processing is made possible by
performing the various types of filtering
3)
that use the
image processing results sent from the camera in the
form of object information metadata. Because filtering
can be applied to metadata that has already been
recorded, you can also search for areas of interest after
recording is finished.
• Audio recording and playback
4)
are also supported
from compatible cameras.
1) Some functions are limited depending on the number of
cameras connected.
2) Some functions are limited depending on which camera
models are connected.
3) To perform motion detection and object detection using
metadata, a camera that supports motion detection by
metadata is required. The use of metadata is supported for
up to 32 cameras.
4) Optional audio amplifiers or speakers are required.
Important
This manual only describes how to install and configure
the NSR. For detailed explanations on how to use the
unit, refer to the User’s Guide (PDF).
System Requirements
The hardware required in order to use this recorder are
as follows.
• Sony Network cameras
Contact your dealer for details about compatible Sony
network cameras.
• Monitor
1)
• USB keyboard
2)
• USB mouse
3)
• USB remote controller
4)
• Network switch
• 1000Base-T/100Base-TX/10Base-T cable
• USB memory device
5)
1) This unit supports HDMI-compatible devices and
computer displays that support RGB input.
The following resolutions can be specified.
- Full High-Definition (1,920 × 1,080)
- WUXGA (1,920 × 1,200)
- Full Wide XGA (1,360 × 768)
- UXGA (1,600 × 1,200)
- SXGA (1,280 × 1,024)
- XGA (1,024 × 768)
2) Use a USB keyboard with a cable. However, keys other
than the standard may not function. Wireless or infrared
USB keyboards may also not function properly.
3) Use a USB mouse with a cable. However, three-button or
wheel mice may not function properly. Wireless or infrared
USB mice may also not function properly.
4) You can use a remote controller to control pan, tilt, and
zoom operations for cameras.
- This unit supports IP Desktop USB controllers from CH
Products. Other remote controllers are not supported.
5) Required when backing up system information such as
logs.
- This unit supports standard USB 2.0 Mass Storage
devices. Depending on the type of USB 2.0 Mass Storage
device, however, errors may occur when writing data to
the device. If errors occur when writing data, use a USB
memory device of a different type.
Note
When using displays that support both HDMI and RGB
input, we recommend using RGB input.