25
1-7. Notes on Replacing Parts and Board
1-7-1. Power Supply during Repairs
AC power adaptor
Use the AC power adaptor when repairing the unit.
1-7-2. Notes for Replacing the VC-1046 Board
Adjustment values of the camera are written to the VC-1046 board in this unit.
For this reason, when the VC-1046 board is replaced, activate the Adjust Manual from the Adjust Station.
Then adjust the camera according to the Adjust Manual and write adjustment values.
Furthermore, write the following data because model-specific information is not recorded in the repairing
board.
•
Destination data
•
USB serial number and product ID
In addition to data write, perform the following after the VC-1046 board is replaced.
•
Updating the MAC address
•
Upgrading the firmware
Destination Data
The destination data stored in the board for repair is different from the destination setting stored in the
board before replacement in some cases.
Destination must be set on the replacement board after installation.
Method of the destination data write:
Start the Adjust Manual in the Adjust Station and execute “Destination data write” on the ADJUST tab.
USB Serial No. and Product ID
The unit is shipped after an ID (USB Serial No.) unique to each unit and an ID (Product ID) unique to
each model have been written.
These IDs have not been written in a brand-new board. Therefore, after the board has been replaced, be
sure to write these IDs to a brand-new board.
Method of the ID writing:
•
When ID is readable
When the unit before repair can be turned on and ID adjustment values can be read using the Adjust
Manual, perform the following work.