Sony ILME-FR7, Help Manual

Page: 62 / 458

Help Guide
Interchangeable Lens Digital Camera
ILME-FR7 / ILME-FR7K
Mounting Upright in a Fixed Location
This topic describes mounting the unit on a desktop or tripod.
Installation note
To protect the lens and the lens connector block of the unit, keep the lens and the cap or cover of the unit attached
until you attach the lens.
To prevent lens failure, do not hold the lens parts while working.
To prevent unit failure, do not hold the camera head while working.
Check the mounting space.
When mounting on a desktop
Mount this unit on a flat surface, taking into consideration the space required for turning the lens and the wiring at
the rear of the unit.
Note
Mount it in a stable location that is not subject to vibration. Locations subject to vibration may cause vibration in the image.
If the unit must be mounted on an inclined surface, keep it within ±15° of the horizontal and take measures to prevent the
unit from falling.
When mounting on a tripod
Attach the tripod to the tripod mounting screw hole on the bottom.
Use a tripod mounting screw with the following amount of protrusion from the mounting surface, and tighten it with a
hand screwdriver.
A: Tripod mounting screws 1/4-20 UNC, ISO 1222 (6.35 mm)
B: Protrusion (4.5 mm to 5.5 mm)
1
62