48
GB
Labeling Folders or Messages — Folder/Message/
User Name (continued)
Entering Characters
Follow the steps below when the display prompts to enter characters
(when the cursor is flashing in step 5 for labeling a folder on page 45, or in
step 4 for labeling a message and in step 3 for changing the user name on
pages 46 and 47 ).
To enter characters
1
Press the jog lever up or down (
>/.
) to select the desired
character.
See the order of character sets on the next page.
2
Press the jog lever (
x
•
B
) briefly to fix.
The cursor moves to the next.
3
Repeat steps
1
and
2
to enter other characters.
To replace characters
When you make a mistake in entering a character or when you want to
change the name, enter again after all characters have been deleted by
pressing ERASE for more than one second or replace some of the
characters as follows.
1
Place the cursor at the character you want to change.
To move the cursor back (to the left), press INDEX/BOOKMARK
briefly.
To move the cursor forward (to the right), press the jog lever (
x
•
B
)
briefly.
2
Press the jog lever up or down (
>/.
) to select the desired
character.
To delete a character and close up the space, place the cursor at the
character you want to delete and press ERASE briefly.
3
Press the jog lever (
x
•
B
) to move the cursor forward and repeat steps
1
and
2
to change other characters.
Note
You cannot insert a character into a name. You must simply replace all the
characters following the character you want to insert.
