Chapter 2
Playback and Recording
29
Cha
p
te
r 2
P
la
yba
c
k
an
d Re
cor
di
n
g
Checking the tape for slack
Using a paper clip or a similar object, turn the reel
gently in the direction shown by the arrow. If the reel
does not move, there is no slack.
Connect the power cord (supplied) to the AC IN
connector. Then, connect the power plug to the wall
outlet.
When you disconnect the power code from the wall
outlet, be sure to unplug the power plug from the wall
outlet first.
Press the POWER switch on the rear panel of the unit to
the “
|
” (ON) position. Then press the ON/STANDBY
button on the front panel.
The [CLOCK SET] screen appears when you turn on the
unit for the first time.
For details on [CLOCK SET], see page 81.
To insert a cassette
After checking the tape for slack, hold the cassette so
that the tape window is facing upward, then insert it into
the unit.
• Do not insert the cassette forcibly. The unit may be
damaged.
• Do not eject/load the cassette in a place subject to light.
The internal sensor of the unit may operate incorrectly
if too much light falls on the unit.
• When inserting a cassette, hold the back edge of the
cassette in the center and push it until the cassette is
inserted deep into the unit. If you hold the ends, the
cassette may not be loaded properly.
• If the cassette does not load or is loaded only halfway,
eject it once, then insert it again. In such a case, if you
insert the cassette forcibly, the cassette may not be
loaded properly or malfunctions may occur.
• It takes a few seconds for the unit to recognize the
cassette and find the proper location on the tape being
loaded.
Preparing the Power Supply
Turning the Power on
Paper clip, etc.
Reel
Inserting/Ejecting Cassettes
Notes
Tape window facing upward
Mini cassette
(Insert the mini cassette
into the center of the
cassette compartment.)
Standard
cassette
