Chapter 1
Overview
17
Cha
p
ter 1
O
v
e
rv
ie
w
q
INDEX MARK button
Press this button during recording to mark an index.
For details on indexes, see “Marking an index” on page 40.
r
END SEARCH button
Press this button to play back the end of the last recorded
part for only 5 seconds and stop automatically. Once
you eject the video cassette, this function does not
operate.
s
1
(on/standby) button
• The command mode of the supplied Remote
Commander is set to VTR4. You cannot change the
command mode setting.
• Set [COMMANDER] in the [OTHERS] menu to
[WIRELESS] to enable the Remote Commander to
control the unit
• In addition to the Remote Commander supplied with
the unit, the unit accepts signals from any Sony
Remote Commander with a command mode set to
VTR4.
To disable control from Remote Commander, set
[COMMANDER] in the [OTHERS] menu to
[CONTROL S].
Before using Remote Commander
Remove the insulation sheet before using the Remote
Commander.
To change the battery of the Remote
Commander
1
While pressing on the tab, inset your fingernail into
the slit to pull out the battery case.
2
Place a new battery with the + side facing up.
3
Insert the battery case back into the Remote
Commander until it clicks.
Note on batteries
When the lithium battery becomes weak, the operating
distance of the Remote Commander may shorten, or the
Remote Commander may not function properly. In this
case, replace the battery with a Sony CR2025 lithium
battery. Use of another battery may present a risk of fire
or explosion.
Notes
WARNING
Battery may explode or leak if mistreated. Do not
recharge, disassemble or dispose of in fire.
Caution
Replace the battery with the specified type only.
Otherwise, fire or injury may result.
Insulation sheet
Tab
