Sony HVO-3300MT, Instructions For Use Manual

Page: 32 / 99

32
Connections
1
Connect a power cord (not supplied) to the AC IN
connector on the rear of the unit.
2
Connect the output signal of the medical equipment
to the input connectors on the rear of the unit.
3
Connect the plug on the power cord to an AC power
supply.
4
Turn on the medical equipment that will act as the
signal source.
Turning the Unit On and
Off
To turn on the unit
1
Set the
?
(on) /
a
(off) switch on the rear panel to the
?
(on) position.
2
Press the
1
(on/standby) switch on the front panel of
the unit.
A splash screen appears on the front panel display when
the unit turns on.
After “BOOTING...” and then the patient ID, current
date, and other information appear on the front panel
display, operations can be performed.
To turn on power or enter standby during normal
operation
Use the 1 (on/standby) switch on the front panel to
switch between turning the unit on and entering the
standby mode.
“FINISHING” appears on the front panel display while
the unit is shutting down. “GOOD BYE” appears and
disappears after shutdown is complete, and the unit enters
standby mode.
During long periods of disuse
Turn off the ? (on) / a (off) switch on the rear panel of the
unit when not using the unit for long periods of time.
1
Press the 1 (on/standby) switch on the front panel of
the unit to enter standby mode.
The 1 (on/standby) indicator lights orange.
2
Set the ? (on) / a (off) switch on the rear panel of the
unit to the a (off) position.
The power is turned off.
Chapter 2: Preparation
1 (on/standby) switch
Front panel