Sony HT-XT2, Operating Instructions Manual

Page: 45 / 227

45
US
U
s
in
g
th
e
V
a
ri
o
u
s
Fu
n
c
ti
o
n
s
/
S
e
tt
in
g
s
[Bluetooth Mode] to [Receiver] or
[Transmitter].
[On]: The system turns on automatically
when you request a BLUETOOTH
connection from a paired BLUETOOTH
device.
[Off]: Off
[Bluetooth Codec - AAC]
This function is only available when you
set [Bluetooth Mode] to [Receiver] or
[Transmitter].
[On]: Enable AAC codec.
[Off]: Disable AAC codec.
• You can enjoy high-quality sound if AAC
is enabled and your device supports AAC.
• When connecting BLUETOOTH-
compatible headphones or speakers, this
setting cannot be changed.
[Bluetooth Codec - LDAC]
This function is only available when you
set [Bluetooth Mode] to [Receiver] or
[Transmitter].
[On]: Enable LDAC codec.
[Off]: Disable LDAC codec.
• You can enjoy more high-quality sound if
LDAC is enabled and your device supports
LDAC.
• When connecting BLUETOOTH-
compatible headphones or speakers, this
setting cannot be changed.
[Wireless Playback Quality]
You can set the transmission data rate
of LDAC playback. This function is only
available when you set [Bluetooth
Mode] to [Transmitter] and [Bluetooth
Codec - LDAC] to [On].
[Auto]: The data transfer rate is
automatically changed depending on
the environment. If audio playback is
unstable in this mode, use the other
three modes.
[Sound Quality]: The highest bit rate is
used. Sound is sent in a higher quality;
however, audio playback sometimes
may become unstable when the link
quality is not good enough.
[Standard]: The middle bit rate is used. It
balances both sound quality and
playback stability.
[Connection]: Stability is prioritized.
Sound quality may be reasonable and
connection status will most likely be
stable. If the connection is unstable, this
setting is recommended.
This setting is for using wireless
speakers (not supplied) as the surround
speakers of the system. For details, see
“Adding Rear Speakers (Wireless
Surround)” (page 33).
[OSD Language]
You can select the language you want
for the system on-screen display.
[HDMI Settings]
• [Control for HDMI] (page 39)
[On]: The Control for HDMI function is
enabled. Devices connected with an
HDMI cable can control each other.
[Off]: Off
• [Standby Linked to TV] (page 39)
This function is available when you set
[Control for HDMI] to [On].
[Auto]: If the input of the system is
[TV] or [Screen mirroring], the system
turns off automatically when you turn
off the TV.
[On]: The system turns off
automatically when you turn off the TV
regardless of the input.
[Off]: The system does not turn off
when you turn off the TV.
Notes
Notes
[Wireless Surround
Settings]
[System Settings]