8
US
Enabling the IR repeater function (when you
cannot control the TV)
When the Bar Speaker obstructs the remote control sensor of the TV,
the TV remote control may not work. In that case, enable the IR
repeater function of the system.
You can control the TV with the remote control of the TV by sending
the remote signal from the rear of the Bar Speaker.
Be sure to check that the remote control of the TV cannot control the TV,
then set “IR REP.” to “ON.” If it is set to “ON” when the remote control can
control the TV, appropriate operation may not be obtained, because of
the interference between the direct command from the remote control
and the command via the Bar Speaker.
1
Press the MENU button on the remote control of the system.
2
Select “SYSTEM” with the
(select) buttons then press the
ENTER button.
3
Select “IR REP.” with the
(select) buttons then press the
ENTER button.
4
Select “ON” with the
(select) buttons then press the
ENTER button.
5
Press the MENU button.
The menu goes off.
On some TVs, this function may not work correctly. In this case, place the
Bar Speaker slightly further away from the TV.
Note
Note
