Sony HT-MT500, Operating Instructions Manual

Page: 49 / 143

49
GB
U
s
in
g
th
e
V
a
ri
o
u
s
Fu
n
c
ti
o
n
s
/
S
e
tt
in
g
s
[Auto]: The data transfer rate is
automatically changed depending on
the environment. If audio playback is
unstable in this mode, use the other
three modes.
[Sound Quality]: The highest bit rate is
used. Sound is sent in a higher quality;
however, audio playback sometimes
may become unstable when the link
quality is not good enough.
[Standard]: The middle bit rate is used. It
balances both sound quality and
playback stability.
[Connection]: Stability is prioritized.
Sound quality may be reasonable and
connection status will most likely be
stable. If the connection is unstable, this
setting is recommended.
This setting is for using wireless
speakers (not supplied) as the surround
speakers of the system. For details, see
“Adding Rear Speakers (Wireless
Surround)” (page 35).
[OSD Language]
You can select the language you want
for the system on-screen display.
[Wireless Subwoofer Connection]
You can perform wireless connection of
the subwoofer again. For details, see
“Performing the Wireless Connection of
the Subwoofer (SECURE LINK)”
(page 39).
[IR-Repeater]
[On]: Remote signals for the TV are sent
from the rear of the main unit (page 43).
[Off]: Turns off the function.
For details, see “Sending the Remote
Signal to the TV via the Main Unit”
(page 43).
[HDMI Settings]
• [Control for HDMI] (page 43)
[On]: The Control for HDMI function is
enabled. Devices connected with an
HDMI cable can control each other.
[Off]: Off
• [Standby Linked to TV] (page 44)
This function is available when you set
[Control for HDMI] to [On].
[Auto]: If the input of the system is
[TV], the system turns off
automatically when you turn off the
TV.
[On]: The system turns off
automatically when you turn off the TV
regardless of the input.
[Off]: The system does not turn off
when you turn off the TV.
• [TV Audio Input Mode] (page 44)
Set this function when the system is
connected to a TV’s HDMI IN jack that
is compatible with Audio Return
Channel. The Audio Return Channel
function is available when you set
[Control for HDMI] to [On].
[Auto]: You can listen to TV sound
from the speakers of the system.
[Optical]: Use this setting when an
optical digital cable is connected.
[Quick Start/Network Standby]
[On]: Shortens the startup time from
standby mode. You can operate the
system quickly after turning it on.
[Off]: Off
[Auto Standby]
[On]: Turns on the [Auto Standby]
function. When you do not operate the
system for about 20 minutes, the
system enters standby mode
automatically.
[Off]: Off
[Wireless Surround
Settings]
[System Settings]