masterpage:Left
lename[D:\SONY SEM 2005\Revision Data\HT-
DDW870\J9050000_2549734151DDW870UCA\2549734151\GB06ADV_HT-DDW870-UCA.fm]
36
GB
model name1[HT-DDW870]
[2-549-734-
15
(1)]
x
CTR XXX dB
(Center speaker level)
x
SUR.L. XXX dB
(Surround speaker (left) level)
x
SUR.R. XXX dB
(Surround speaker (right) level)
x
SB XXX dB
(Surround back speaker level)
x
S.W. XXX dB
(Sub woofer level)
Initial setting: 0 dB
You can adjust from –10 dB to +10 dB in 1 dB steps.
x
COMP. XXX
(Dynamic range compressor)
Lets you compress the dynamic range of the sound
track. This may be useful when you want to watch
movies at low volumes late at night.
• OFF
The dynamic range is not compressed.
• STD
The dynamic range is compressed as intended by the
recording engineer.
• MAX
The dynamic range is compressed dramatically.
Tip
Dynamic range compressor lets you compress the
dynamic range of the soundtrack based on the dynamic
range information included in the Dolby Digital signal.
“STD” is the standard setting, but it only enacts light
compression. Therefore, we recommend using the
“MAX” setting. This greatly compresses the dynamic
range and lets you view movies late at night at low
volumes. Unlike analog limiters, the levels are
predetermined and provide a very natural compression.
Note
Dynamic range compression is possible with Dolby
Digital sources only.
x
EFCT. XXX (Effect level)
Initial setting: STD
Lets you adjust the “presence” of the surround effect in
3 levels – MIN (minimum effect), STD (standard
effect) and MAX (maximum effect).
Note
This parameter is valid only when you use a sound
field selected with the MOVIE or MUSIC buttons.
Resetting sound fields to the
initial settings
Use the buttons on the receiver for the operation.
1
Press
?/1
to turn off the power.
2
While holding down 2CH, press
?/1
.
“SF. CLR.” appears in the display and all
sound fields are reset to the initial setting.
D.RANGE
GB01COV_HT-DDW870-UCA.book Page 36 Monday, June 20, 2005 4:43 PM
