masterpage:Left
lename[E:\SEM_Janet\DDW760_3rdrevision\J9040000_4252086131DDW760GB\4252086131\
GB04BSC_HT-DDW760-U.fm]
20
GB
model name1[HT-DDW760]
[4-252-086-
13
(1)]
1
Press input buttons to select the input.
The selected input appears in the display.
2
Turn on the component and start
playback.
Note
If you select the VCR or DVD player, set the
TV’s video input to match the component you
selected.
3
Turn MASTER VOLUME –/+ to adjust
the volume.
Note
To avoid damaging your speakers, make sure that
you turn down the volume before you turn off the
receiver.
To mute the sound
Press MUTING on the remote.
The muting function will be canceled when you
do the following.
• Press MUTING on the remote again.
• Turn the power off.
• Increase the volume.
To use the headphones
Connect the headphones to the PHONES jack.
When the headphones are connected, speaker
output is automatically canceled and “SP” does
not light up in the display.
(Models of area code CEL, CEK only)
You can select the audio directly from the
components connected to the MULTI CH IN
jacks. This enables you to enjoy high quality
analog inputs such as DVD. When MULTI CH
IN is selected, the tone and sound field cannot be
used.
Press MULTI CH IN.
Press again to cancel the MULTI CH IN
function.
Note
To optimize the sound balance of this system, we
recommend that you set the speaker configuration of
your DVD player as follows:
When MULTI CHANNEL
DECODING indicator lights up
(Models of area code CEL, CEK only)
The MULTI CHANNEL DECODING indicator
lights up when the receiver is decoding multi
channel sources.
However, this indicator does not light up if you
select 2CH STEREO mode.
Amplifier Operation
Selecting the component
To select the
Press
VCR
VIDEO 1
or VIDEO 2
Satellite tuner
VIDEO 2
DVD player
DVD
MD or tape deck
MD/TAPE
CD player
CD
Built-in tuner (FM/AM)
TUNER FM/AM
Listening to multi channel
sound
— MULTI CH IN
Speaker type
Settings
FRONT
SMALL
CENTER
SMALL
SURROUND/REAR
SMALL
SUB WOOFER
YES
GB01COV_HT-DDW760-U.book Page 20 Tuesday, April 20, 2004 3:10 PM