34
GB
Using the controls on the
receiver
1
Turn INPUT SELECTOR to select the FM
or AM band.
2
Press TUNING MODE repeatedly to select
“PRESET T.”.
3
Press or TUNING – repeatedly
to select the preset station you want.
1
Press TUNER repeatedly to
select the FM or AM band.
You can also use INPUT SELECTOR on
the receiver.
2
Tune in the preset station you
want to create an index name
for (page 33).
3
Press AMP MENU.
“T.TONE” appears on the display.
4
Press
V
/
v
repeatedly to select
“NAME IN”, then press
or
b
.
The cursor flashes and you can select a
character.
5
Press
V
/
v
to select a character,
then press
B
/
b
to move the
cursor to the next position.
If you made a mistake
Press
B
/
b
until the character you want to
change flashes, then press
V
/
v
to select
the correct character.
Tips
• You can select the character type as follows
by pressing
V
/
v
.
Alphabet (upper case)
t
Numbers
t
Symbols
• To enter a blank space, press
b
without
selecting a character.
6
Press .
The name you entered is registered.
\
Switching between
digital and analog audio
(INPUT MODE)
When you connect components to both digital
and analog audio input jacks on the receiver,
you can fix the audio input mode to either of
them, or switch from one to the other,
depending on the type of material you intend
to watch.
1
Turn INPUT SELECTOR on the
receiver to select the input.
You can also use the input buttons on the
remote.
2
Press INPUT MODE repeatedly
on the receiver to select the
audio input mode.
The selected audio input mode appears on
the display.
Audio input modes
x
AUTO
Gives priority to digital audio signals when
there are both digital and analog connections.
If there are no digital audio signals, analog
audio signals are selected.
x
ANALOG
Specifies the analog audio signals input to the
AUDIO IN (L/R) jacks.
Note
Some audio input modes may not be set up
depending on the input.
Naming preset stations
Other Operations