13
Installation
Installation
Connecting a Camera Control Unit
(CCU)
When operating the camera in a system with a CCU, connect
between the CCU connector of the camera and the CAMERA
connector of the CCU, using a triax cable.
When required, secure the cable, using the supplied cable
clamp belt.
To use the cable clamp belt
1
Insert the belt bracket
C
into hole
A
or
B
of the cable
clamp belt.
2
1
Remove the back screw-hole cover on the top of
the camera and
2
secure the cable clamp belt to the
camera, using the two supplied screws (+B3
×
10).
3
1
Release the buckle,
2
bundle the cable with the
belt,
3
then lock the buckle again.
4
Adjust the length by pulling down the end of the belt.
Attaching a Lens
For information on handling lenses, refer to the operation
manual for the particular lens
1
Push the lens fixing lever
A
upward and remove the
lens mount cap from the lens mount.
2
Align the lens’ alignment pin
C
with the notch
B
in
the upper part of the lens mount and insert the lens
into the mount.
3
While supporting the lens, push the lens fixing lever
A
downward to secure the lens.
4
Connect the lens cable to the LENS connector.
5
Secure the lens cable with the cable clamp.
To use a large studio-use lens
A large studio-use lens can be used with this camera by
mounting the camera on an optional HDLA1500-series Large
Lens Adaptor.
When attaching the camera hangers to the camera, always
use the screws (+B4
×
10) supplied with the lens adaptor.
For details, refer to the operation manual supplied with the
HDLA1500-series adaptor.
A
B
C
1
2
1
2
3
Note
OFF
ON
SEL
WHT
BLK
SHUT
TER
RET
L
E
N
S
INET
ERCO
M LE
VEL
MIC
VF
4
1
2
3
C
A
B
5