Sony HKSR-9003, Operation Manual

Page: 79 / 177

Recording 79
Ch
apt
er 4
Re
c
o
rdin
g/
Pla
y
ba
c
k
1
Turn the SELECT/ENTER dial to
select the scale to display.
Full Peak: Display 0 dBFS as the peak value.
Full Ref: Display the reference level (+4
dBu) as 0 dB.
Fine: Display a scale with steps of 0.25 dB
centered around.
2
Press the SELECT/ENTER dial.
To set recording audio levels
The Audio Setup >REC LEVEL in the VTR
menu allows you to set recording audio levels for
the individual channels.
Note
Recording levels cannot be set during playback.
1
Turn the SELECT/ENTER dial to
select a channel (1 to 12).
2
Press the SELECT/ENTER dial.
The current recording level of the selected
channel is shown as a hexadecimal number.
UNI is shown for channels whose recording
levels have not been changed.
3
Turn the SELECT/ENTER dial to
select UNI/VAL, and press the dial.
If you do not need to change the recording
level, set the recording level of the channel
selected in steps
1 and 2 to UNI and proceed
to step 5 . If you do need to change the
recording level, set the recording level of the
channel selected in steps
1 and 2 to VAR and
proceed to step 4 .
4
Turn the ADJUST knob to set the
recording level.
Turn clockwise to raise the level and turn
counterclockwise to lower it.
To reset the setting
Turn the SELECT/ENTER dial to move the
cursor to RESET, and press the dial.
5
Press the SELECT/ENTER dial.
6
Repeat steps 1 and 2 to select other
channels and steps 3 and 4 to set the
recording levels of those channels.
7
When you are finished, turn the
SELECT/ENTER dial to select END,
and press the dial.
Use the VTR >TC Setup menu to make timecode
and user bits settings.
To display the TC Setup menu
Press the menu selection button “TC.”
Cursor
Recording levels
Channel numbers
Recording level settings
Making Timecode and User Bits
Settings
Control panel
TC button
TC Setup menu
SELECT/
ENTER dial