14
31. Pull out the redundant part of the harness to the outside.
Pull out the entire redundant part of the harness to the outside.
32. Fix the harness (DC-OUT-POWER) with the two clampers as shown below.
•
Pass the harness with a connector terminal (white) through the two clampers on the rear side as shown below.
•
Ensure an extra length of the harness of 12 cm or more from the rear clamper.
33. Attach the harness (DC-OUT- POWER) assembly, and then tighten the two screws.
Note
Harness (DC-OUT-POWER) assembly
Redundant part of
the harness
Note
Extra length of the harness
of 12 cm or more
Harness (DC-OUT-POWER)
assembly
Clampers
Connector terminal (white)
PSW2 x 5
Summary of Contents for HKC-WL50
Page 17: ...15 34 Attach the SW 1742 board and then tighten the screw PSW3 x 6 SW 1742 board ...
Page 24: ...22 13 Attach the rating label to the camera body Rating label ...
Page 26: ...24 Revision History Date History Contents 2019 3 1st Edition 9 932 686 01 ...
Page 28: ...HKC WL50 SY J E 9 932 686 01 Sony Corporation Printed in Japan 2019 3 08 2019 ...
