Sony HDXS-C200, Service Manual

Page: 88 / 106

88
Powered-off replacement parts
C
h
ap
te
r 6
P
a
rt
s
R
e
pl
ac
eme
n
t
DVD/CD drive replacement
Disk drive removal
1
Power off the unit (see “How to power off the server”
on page 45 ) and then remove the rear and front lids
(see “Front lid removal” on page 83 ) to access the
part.
2
disconnect the 40-pin IDE cable and the mini 4-pin
power connector from the rear of the DVD/CD drive.
3
Remove the two Flat Head, #6-32x5 mm screws on the
DVD/CD mounting bracket and lift the drive clear of
the chassis.
4
Remove the mounting bracket from the DVD/CD
drive.
5
Remove the DVD/CD adapter board from the back of
the drive by removing the two Pan Head, M2x8mm
screws.
Disk drive installation
1
Secure the DVD/CD adapter board to the new DVD/
CD using the two Pan Head, M2x8 mm screws
previously removed.
2
Insert the new DVD/CD drive into the mounting
bracket and snap the fingers into the slim DVD/CD
Drive mounting holes.
3
Replace the DVD/CD drive into the chassis and secure
the mounting plate using the two Flat Head, #6-
32x5 mm screws previously removed, taking care not
to trap any cables.
4
Connect the 40-pin IDE cable to the adapter board and
connect the mini 4-pin connector to the adaptor board.
5
Replace the front and rear lids (see “Front lid
replacement” on page 83 ) and power on the server
(see “How to power on the system” on page 45 ).
Checks after replacement
After replacement, check the DVD/CD drive is
functioning by inserting a known-good disk and reading
the data from it.