Sony HDXS-C200, Service Manual

Page: 73 / 106

73
Error Messages
C
h
ap
te
r
5
T
rou
b
le
s
h
o
o
ti
ng
Windows messenger error
messages
Failure or degraded operation of the Media RAID or OS
RAID arrays can be alerted to an operator using Windows
Messenger to a nominated client PC. See the
HDXC-C030
HDXC-B030 HDXC-X030 HDXC-L030 Installation
Manual
for details of the Windows Messenger service.
A typical message is displayed below.
The service engineer should confirm the message at the
client screen and investigate further using the 3ware utility
(see
“3ware disk manager” on page 55 ).
0xD6h R A G R Trying boot device selection
0xD7h R A G A Trying boot device selection
0xD8h A R O R Trying boot device selection
0xD9h A R O A Trying boot device selection
0xDAh A R G R Trying boot device selection
0xDBh A R G A Trying boot device selection
0xDCh A A O R Trying boot device selection
0xDEh A A G R Trying boot device selection
0xDFh A A G A Trying boot device selection
Pre-EFI Initialization (PEI0 Core
0xE0h R R R O Started dispatching early
initialization modules (PEIM)
0xE1h R R A O Initial memory found, configured
and installed correctly
0xE2h R R R G Reserved for initialization module
use (PEIM)
0xE3h R R A G Reserved for initialization module
use (PEIM)
Driver Execution Environment (DXE) Core
0xE4h R A R O Entered EFI driver execution
phase
0xE5h R A R G Started dispatching drivers
0xE6h R A A O Started connecting drivers
DXE Drivers
0xE7h R A A G Waiting for user input
0xE8h A R R O Checking password
0xE9h A R R G Entering BIOS setup
0xEAh A R A O Flash update
0xEEh A A A O Calling Int 19. One beep unless
silent boot is enabled.
0xEFh A A A G Unrecoverable boot failure/S3
resume failure
Runtime Phase/EFI Operating System Boot
0xF4h R A R R Entering sleep state
0xF5h R A R A Exiting sleep state
0xF8h A R R R Operating system has requested
EFI to close boot services
(ExitBootServices ( ) has been
called)
0xF9h A R R A Operating system has switched to
virtual address mode
(SetVirtualAddressMap ( ) has
been called)
0xFAh A R A R Operating system has requested
the system to reset (ResetSystem
( ) has been called)
Pre-EFI Initialization Module (PEIM)/Recovery
0x30h O O R R Crisis recovery has been initiated
because of a user request
Code
MSB Bi
t 2
Bi
t 1
LSB
Description
0x31h O O R A Crisis recovery has been initiated
by software (corrupt flash)
0x34h O G R R Loading crisis recovery capsule
0x34h O O R A Handing off control to the crisis
recovery capsule
0x3F0h G G A A Unable to complete crisis recovery
Code
MSB Bi
t 2
Bi
t 1
LSB
Description