6
Locations and Functions
of Parts
Front
a
Front tally lamp
The tally lamp lights when a call signal is generated in
response to the pressing of a CALL button or a tally signal
input to the EXT I/O connector.
You can attach the supplied number plate to display the
camera number.
The front tally function cannot be operated during a battery
alarm operation.
b
LENS connector (12-pin)
Connect the lens cable. The camera can control the lens
functions through this cable.
Connect the lens cable so that
v
is at the top.
c
Lens cable clamp
To secure the cable of the lens (not supplied).
d
Lens mount stopper rubber
After attaching a lens, attach the rubber to prevent the lens
from becoming loose.
Before removing the lens, remove this rubber from the boss on
the front panel.
e
Lens mount cap
The cover can be removed by moving the lens lock lever
upwards.
Always keep the lens mount covered with this cap when a lens
is not attached.
f
Lens lock lever
Move the lever down to secure the lens in the lens mount.
Rear
a
Rear tally lamp
The tally lamp lights when a call signal is generated in
response to the pressing of a CALL button or a tally signal
input to the EXT I/O connector.
The rear tally lamp also serves as a battery alarm function.
If the voltage of the XLR input connected to the camera
decreases, the rear tally lamp flashes. If the voltage
approaches the limit, the rear tally lamp switches to high-
speed flashing.
The alarm voltage for starting flashing can be set in the
BEFORE END item of the BATTERY ALARM page of the
MAINTENANCE menu, and the alarm voltage for switching to
high-speed flashing can be set in the END item.
If you want to give priority to the tally function and call function,
set the BATTERY ALARM item of the BATTERY ALARM page
of the MAINTENANCE menu to OFF.
For details, see “MAINTENANCE Menu” (page 38).
b
MENU SEL (menu select) knob/ENTER button (rotary
encoder)
Turn the knob to select items and settings in the menu
displayed on the monitor, then press the knob to apply
(confirm) the selection.
c
DISPLAY/MENU switch
Select the display on the monitor connected to the SDI MONI
connector.
DISPLAY:
Displays various textual information and markers,
such as messages showing the camera settings and
operating status, the center marker, and the safety zone
marker, in addition to camera images.
z
(OFF):
Displays images only.
MENU:
Displays menus for camera settings, in addition to
camera images.
d
EXT I/O (external input/output) connector (D-sub 9-
pin)
Connect an external device.
For details about pin assignment, see “Pin Assignment”
(page 52).
e
REF IN indicator
Displays the status of the external sync reference input signal.
Note
