12
Resetting the network configuration
information
NETWORK ALL RESET:
Restore the network related
information to the default state.
Setting the Transport Conversion
Function
This function converts the protocol of the camera network
system to a simple protocol within the HDC-P50 for
communication with the CNA-1 which uses a simple protocol.
This enables camera control using transmission paths that do
not support the camera network system protocol or have high
latency.
You can also toggle this function on/off on the <SIMPLE
PROTOCOL> page.
Supported networks
The Internet cannot be used. Use a secure, private network
that is independent of other systems and networks, and which
meets the following conditions.
• Latency: 1 second or lower (one way)
• Bandwidth: 100 Kbps or higher for each camera
When the transport conversion function is enabled, the RCP/
MSU indicator is disabled and is always lit.
For details about configuring the CNA-1, refer to the operation
manual of the CNA-1.
Camera controlled directly from RCP (one-to-
one)
Transport conversion using RS422
Setting the Focus Assist Functions
Using the OPERATION menu, the assist functions for easier
focusing can be displayed on a monitor connected to the SDI
MONI connector (VF setting).
Adding the VF detail signal
Adding the VF detail signal to sharp edges in the image on a
monitor screen makes it easier to check the focusing condition
by observing changes in the detail signal or in the color
converted from the detail signal (color detail).
The focus setting where the detail signal becomes strongest is
the best focus setting.
1
Turn on the camera.
2
Set the DISPLAY/MENU switch to MENU while holding
the MENU SEL knob/ENTER button pressed.
The camera enters Menu mode, and “TOP” is displayed at
the upper right corner of the screen.
3
Turn the MENU SEL knob/ENTER button to move the
arrow marker (
,
) to TOP and press the MENU SEL
knob/ENTER button.
The TOP MENU screen appears.
4
Turn the MENU SEL knob/ENTER button to move the
arrow marker (
,
) to OPERATION and press the
MENU SEL knob/ENTER button.
The CONTENTS page of the OPERATION menu is
displayed.
Note
<NETWORK RESET> M17 TOP
NETWORK ALL RESET
Network hub
(A)
HDC-P50
Lens
(for ENG/EFP)
Network hub
(B)
RCP
CNS Mode:
Bridge
CNA-1 (B)
CNS Mode: Bridge
Emulation Mode:
CAM
Network
: LAN cable
HDC-P50
Lens
(for ENG/EFP)
Network hub
RCP
CNS Mode:
Bridge
CNA-1 (B)
CNS Mode: Bridge
Emulation Mode: CAM
RS422
: LAN cable
1)
Connect the REMOTE
connector of the HDC-P50 to
the EXT I/O connector of the
CNA-1.
RS232 is not supported.
1)
<TOP MENU>
USER
USER MENU CUSTOMIZE
ALL
OPERATION
PAINT
MAINTENANCE
FILE
DIAGNOSIS
CONTENTS 00 TOP
01.<VF DISPLAY>
02.<VF MARKER>
03.<VF DETAIL>
04.<DYNAMIC FOCUS>
05.<FOCUS POSITION METER1>
06.<FOCUS POSITION METER2>
07.<FOCUS ASSIST>
08.<ZEBRA>
09.<CURSOR>
10.<BOX CURSOR FILE>
