Chapter 4 Adjustments and Settings for Recording
Chapter 4
Adjustments and Settings for Recording
4-17(E)
4-6-2 Selecting the Items for
Which an ‘!’ Mark to Light
Use the ‘!’ IND 1 and ‘!’ IND 2 pages of the
OPERATION menu to select the items for which an
exclamation mark (!) lights in the viewfinder.
The settings on this page can be confirmed by pressing
the STATUS/CANCEL switch towards STATUS
when the DISPLAY switch is set to ON or OFF.
Use the following procedure to make the selection.
1
Set the DISPLAY switch to MENU.
2
Turn the MENU SEL knob/ENTER button, to
display the ‘!’ IND or ‘!’ IND 2 page, then press
the MENU SEL knob/ENTER button.
Example: ‘!’ IND 1 page
The current settings of each item appear to the
right of the item.
The above figure shows the default settings. All
items have been set to ON at the factory. However
the conditions whether an exclamation mark (!)
lights up depend on the settings at the NORMAL
column. You can change these conditions.
‘!’ IND 1 page:
Item
Condition to light (Factory setting)
ND
When any ND filter other than 1 is
selected
CC
When any CC filter other than B is
selected
WHITE
When the WHITE BAL switch (white
balance memory) is set to the position
other than A and B
D5600K
When D5600K is set to ON on the
OTHERS page. When D5600K is set to
OFF on the OTHERS page, the ! mark
does not light even if IND is set to ON on
this page
GAIN
When GAIN switch is set to any position
other than L
SHUTT
When the electronic shutter is used
FAN
When FAN mode setting with the
MAINTENANCE menu is other than
AUTO1
EXT
When the lens extender is in use. When
the lens extender is not in used, the !
mark does not light even if IND is set to
ON
FORMAT
When the format other than 23.98PsF is
selected
‘!’ IND 2 page:
Item
Condition to light (Factory setting)
CHU OUT
When any output other than 4:4:4 is
selected
CHU OPE
When any mode other than NORMAL is
selected
META DATA When meta data is set to OFF
3
Perform the desired settings for each item.
Whether the exclamation mark should light or not
is set in the IND column.
1
Turn the MENU SEL knob/ENTER button to
move the arrow marker (
c
) to the item you
want to set, then press the MENU SEL knob/
ENTER button.
The arrow marker (
c
) changes to a question
mark (?).
2
Turn the MENU SEL knob/ENTER button to
select ON or OFF as desired, then press the
MENU SEL knob/ENTER button.
The “?” mark changes back to the arrow marker
(
c
) .
When you select ON in step
2
, set the condition
for lighting in the NORMAL column by selecting
the normal condition where the ! mark dones not
light.
When you select OFF, proceed to step
4
.
3
Turn the MENU SEL knob/ENTER button to
move the arrow marker (
c
) to the NORMAL
column of the item you select in step
1
, then
press the MENU SEL knob/ENTER button.
The arrow marker (
c
) changes to a question
mark (?).
<'!' IND 1> 2
[IND] [NORMAL]
ND :
c
ON 1---
CC : ON -B--
WHITE : ON -AB
D5600K: ON OFF
GAIN : ON L--
SHUTT : ON OFF
FAN : ON AUTO1
EXT : ON OFF
FORMAT: ON 23.98PsF
