Sony HCD-GX45 - System Components, Operating Instructions Manual

Page: 12 / 40

12
GB
You can make a program of up to 25 steps from
all the discs in the order you want to play them.
You can synchro record the programmed tracks
onto a cassette tape (page 17).
MP3 audio tracks cannot be played on
MHC-GX25 and MHC-RG220 (except for
European and Russian models).
Using the display window
1
Press CD.
2
Press PLAY MODE in stop mode
repeatedly until “PGM” appears.
3
Press D.SKIP (or DISC 1 – 3 or DISC
SKIP/EX-CHANGE on the unit) to select
a disc.
To program all the tracks on a disc at once,
proceed to step 5 with “AL” displayed.
4
Press . or > repeatedly until the
desired track number appears.
When programming an MP3, press
ALBUM – or + to select album, then press
. or > repeatedly until the desired
track number appears.
5
Press ENTER.
The track is programmed.
The program step number appears,
followed by the total playing time.
6
Program additional discs or tracks.
7
Press N .
Program Play starts.
Other operations
Tips
• The program you made remains after Program Play
finishes. To play the same program again, press CD,
then press
N . However, the program is cleared
when you open the disc tray.
• “– –.– –” appears when the total CD program time
exceeds 100 minutes, or when you select a CD track
whose number is 21 or over, or when you select an
MP3 audio track.
Creating your own
program
— Program Play
Selected track number
Disc tray number
Total playing time
(including selected track)
To program Repeat steps
Other discs 3 and 5
Other tracks on the
same disc 4 and 5
Other tracks on
other discs 3 to 5
To Do this
Cancel Program
Play Press PLAY MODE in stop
mode repeatedly until “PGM”
disappears.
Clear a track from
the end Press CLEAR in stop mode.