Additional Information
134
4
Touch the “×” displayed on the screen
with the corner of the supplied “Memory
Stick Duo.”
The position of the “×” changes.
If you did not press the right spot, start from
step 4 again.
b
Note
• You cannot calibrate the LCD screen if you have
rotated the LCD panel and set it with the LCD screen
facing out.
On handling the casing
• If the casing is soiled, clean the camcorder
body with a soft cloth lightly moistened with
water, and then wipe the casing with a dry soft
cloth.
• Avoid the following to avoid damage to the
finish.
– Using chemicals such as thinner, benzine,
alcohol, chemical cloths, repellent and
insecticide.
– Handling with above substances on your
hands.
– Leaving the casing in contact with rubber or
vinyl objects for a long period of time.
About care and storage of the lens
• Wipe the surface of the lens clean with a soft
cloth in the following instances:
– When there are fingerprints on the lens
surface.
– In hot or humid locations
– When the lens is exposed to salty air such as
at the seaside.
• Store in a well-ventilated location subject to
little dirt or dust.
• To prevent molds periodically clean the lens
as described above.
It is recommended you operate your camcorder
about once a month to keep it in an optimum
state for a long time.
To charge the pre-installed button-type
battery
Your camcorder has a pre-installed button-type
battery to retain the date, time, and other
settings even when the POWER switch is set to
OFF (CHG). The pre-installed button-type
battery is always charged while you are using
your camcorder but it will get discharged
gradually if you do not use your camcorder. The
button-type battery will be fully discharged in
about 3 months if you do not use your
camcorder at all. However, even if the pre-
installed button-type battery is not charged, the
camcorder operation will not be affected as long
as you are not recording the date.
Procedures
Connect your camcorder to a wall socket using
the supplied AC Adaptor or Handycam Station,
and leave it with the POWER switch set to OFF
(CHG) for more than 24 hours.
Removing dust from inside the
viewfinder
1
Remove the eyecup.
1
Pull out the viewfinder.
2
Remove the screw on each side of the
eyecup and viewfinder using a
screwdriver.
3
Remove the eyecup.
2
Remove dust from inside the eyecup and
viewfinder with a blower.
3
Reverse steps
2
and
3
to re-attach the
eyecup and replace the screws.
b
Note
• Do not drop or bend the eyecup shaft. Be careful
when handling the eyecup.
2
2
3
1
Summary of Contents for Handycam DCR-PC108E
Page 5: ...Read this first 5 ...
