NAS-E300HD.GB.4-115-698-
11
(1)
3
GB
To reduce static noise during
reception of a weak FM stereo
station
Press FM MODE repeatedly until “MONO”
appears in the display to switch the stereo
reception to monaural.
To change the AM tuning interval
The AM tuning interval is factory set to 9 kHz
(or 10 kHz for some areas; this function is not
available on the European model).
1
Tune in any AM station, and then
press
to turn off the unit.
2
Press DISPLAY to display the clock.
The clock will be displayed for 8 seconds. Do
step 3 while the clock is displayed.
3
While pressing and holding TUNE +
on the main unit, press
on the
main unit.
All the preset AM stations are erased. To reset
the interval to the factory setting, do the same
procedure.
Notes on listening to the DAB service
When tuning in a DAB service, it may take a few
seconds before you hear any sound.
Primary service is automatically received when
secondary service ends.
Presetting radio stations or
DAB services*
By presetting FM stations, AM stations or DAB
services*, you can easily tune them in later merely
by selecting the corresponding preset number. You
can preset up to 20 FM stations or DAB services
and up to 10 AM stations.
* For the UK model only
1
Turn in the desired radio station or
DAB service (“Selecting an FM/AM
radio station or a DAB service” on
page 37).
2
Press TUNER MEMORY.
The preset number flashes.
Preset number
3
Press TUNE +/– to select a preset
number, and then press ENTER.
The station or service is preset.
Preset number
4
Repeat steps 1 to 3 to store other
stations or services.
The preset stations or services are retained for
about half a day even if you disconnect the
power cord or if a power failure occurs.
To listen to the preset station or
service
1
Press TUNER/BAND repeatedly to
select “DAB”, “FM”, or “AM”.
2
Press TUNING MODE repeatedly until
“PRESET” appears in the display.
3
Press TUNE +/– to select the preset
station.
Tip
You can select the preset station using the numeric
buttons on the remote control.
For example, when you select the station which preset
number is 15, press 1 and 5, and then press ENTER.
If you enter unavailable preset number, “––” appears in
the display and you cannot select the station.
