36
The INFORMATION Menu
Lamp Mode
Sets the lamp brightness in the projection.
High:
Illuminates the projected image
brightly.
Standard:
Reduces fan noise and power
consumption. The brightness of the
projected image will be lower compared
with the “High” setting.
Lens Control
When set to “Off,” the LENS key on the
Remote Commander, and the LENS
CONTROL key on the projector do not
function.
Direct Power On/Off function
If you will be using a circuit breaker to turn the
power for the entire system on and off, set the
direct power on function to “On”. You can turn
the power on/off without pressing the power
key on the projector.
High Altitude Mode
Off:
Use this setting when using the projector
at normal altitudes.
On:
Use this setting when using the projector
at an altitude of 1,500 m (4,921 feet) or
higher.
Security Lock
Turns on the projector’s security lock
function.
Off:
Turns off the security lock function.
On:
Turns on the security lock function,
which locks the projector once a
password has been set.
For details, see “Using the security
lock” on page 25.
The INFORMATION
Menu
The INFORMATION menu displays the
horizontal and vertical frequencies of the
input signal and the used time of the lamp.
fH
Displays the horizontal frequency of the
input signal.
The displayed value is approximate.
fV
Displays the vertical frequency of the input
signal.
The displayed value is approximate.
Lamp Timer
Indicates how long the lamp has been turned
on.
IP Address
Displays the IP address that is set for the
projector.
Subnet Mask
Displays the subnet mask that is set for the
projector.
These only display on the screen.
Menu Items
Note
I n p u t A
f H : 4 8 . 4 7
k H z
f V: 6 0 . 0 0
H z
N o . 2 3
1 0 2 4 x 7 6 8
L a m p T i m e r :
4 H
I N F O R M AT I O N
IP Address:
1 9 2 . 1 6 8 . 0 . 1
S u b n e t M a s k :
2 5 5 . 2 5 5 . 0 . 0
Memory
number of
a input
signal
Signal
type
