5-25
SEL24105G
7. “MF ROTATION STOP” is displayed, press the ENTER key.
8. “LENS DEVICE (FOCUS RING) CHECK OK” is displayed,
press the ENTER key.
9. When the ENTER key is pressed, recording the adjustment data
and releasing from adjustment mode are performed automatically,
and “FINISHED” is displayed when the process is completed,
then click the [OK] button.
(2) Lens Device2 (S)
• Adjust the MR sensor of focus and zoom.
• Adjust the mechanical end of focus and zoom.
• Adjust the frequency of focus PWM.
• Perform thermistor inspection.
Subject
Not required
Operation on Lens side
• Zooming ring
Type of the camera
ILCE-5000
Shooting Mode of the camera P mode (Program Auto)
Adjusting Method
1. Click the [Lens Device2 (S)] button in the Adjustment and In-
spection.
2. The START screen is displayed, after the preparation of adjust-
ment is completed, press the ENTER key.
3. Automatically starts the focus MR adjustment.
4. After the focus MR adjustment is completed, message screen is
displayed in the following. Set the zooming ring to the WIDE
end (focal length: 24 mm).
Zooming ring
– Continued on next page –
