52
To use an external audio device, or a
microphone other than the supplied
microphone, change the following settings.
1
Select the input source.
Set the INPUT 1/INPUT 2 switches
according to the devices connected to
the INPUT 1/INPUT 2 jacks.
• If you connect a device that does not
s48V phantom power, malfunction
may result from setting this switch to
MIC+48V. Check before connecting the
device.
• When there is no audio device connected to
an INPUT jack, set the INPUT switch of
that jack to LINE to prevent noise.
2
Set the input level of the
microphone.
• Set the input level to the sensitivity of
an XLR microphone you are using
with [INPUT1 TRIM]/[INPUT2
TRIM] in the menu (p. 93). [0dB] will
be appropriate for the supplied
microphone (ECM-XM1*).
* NEX-EA50UH/EA50EH/EA50H only
• You can set an input level between
-60 dBu (+12dB) and -30 dBu
(-18dB) by 6dB. The default setting is
-48 dBu (0dB).
3
Select the channel you want to
record.
Using the CH1/CH2 switches, select the
source to be recorded on each channel.
When the CH1 switch is set to INT MIC
When the CH1 switch is set to INPUT 1
Recording sound from an
external audio device
Audio devices
Switch
position
External audio device
(mixer, etc.)
LINE
Dynamic microphones or
microphones with a built-
in battery
MIC
+48V powering
(
Phantom powering)
microphone
MIC+48V
Input source and recorded
channel
CH2
switch
setting
INT MIC (L)
INT MIC (R)
CH1
CH2
INT MIC (mono)
INPUT 1
CH1
CH2
INT MIC (mono)
INPUT 2
CH1
CH2
Input source and recorded
channel
CH2
switch
setting
INPUT 1
INT MIC (mono)
CH1
CH2
INPUT 1
CH1
CH2
INPUT 1
INPUT 2
CH1
CH2
Audio setup (Continued)
