18
Transmitter Settings
When using multiple channels (up to six),
the two RF modes, [Wide Band] and
[Narrow Band], cannot be used
simultaneously. Select only one RF mode
during use. In addition, Wi-Fi and other
environmental interference may reduce the
actual number of channels that can be used
simultaneously.
Selecting the RF mode
1
Press and hold the POWER/MUTING
button to turn off the unit.
2
Press and hold the POWER/MUTING
button (about 1 second) while holding
down the channel selection button.
“0” blinks in the channel display.
3
Press the channel selection button to
select “1” or “a.”
4
Press and hold the channel selection
button.
Selecting the channel
1
Press and hold the channel selection
button while the unit is turned on.
The channel display blinks.
2
Press the channel selection button to
select the channel.
3
Press and hold the channel selection
button to apply the channel selection.
If you change the channel setting on the
transmitter, be sure to change the channel
setting on the receiver to the same channel.
If the receiver channel and transmitter
channel are not identical, audio will not be
output.
Channel Display
Each channel will appear as follows in the
transmitter’s channel display.
Caution
Caution
RF mode
Channel number
Wide Band
(WIDE)
1 2 3
4 5 6
Narrow
Band
(NARROW)
a b c
d e f
Summary of Contents for DWZ-B50GB
Page 31: ...Sony Corporation ...
