Sony DWZ-B50GB, Operating Instructions Manual

Page: 14 / 31

14 Receiver Settings
Receiver Settings
Half-Rack Receiver (ZRX-
HR50)
Use the rotary encoder and the ESC button
to configure settings on the ZRX-HR50
half-rack receiver. Perform setting
operations as follows.
Confirm: Press the rotary encoder.
Move cursor: Turn the rotary encoder.
Cancel: Press the ESC button.
Displaying the settings menu
Press the rotary encoder to display the
[Setup] screen in the display.
To return to the main screen from the
[Setup] screen, press the ESC button.
Configuring the receiving
channel settings
Two RF modes (channel modes), [Wide
Band] and [Narrow Band], are available on
the DWZ.
Each RF mode consists of six channels.
Select the appropriate channel according to
your intended use. The RF mode is set to
[Wide Band] and the transmission channel
is set to 1 under factory default settings.
When using multiple channels (up to six),
the two RF modes, [Wide Band] and
[Narrow Band], cannot be used
simultaneously. Select only one RF mode
during use. In addition, Wi-Fi and other
environmental interference may reduce the
actual number of channels that can be used
simultaneously.
To select the RF mode
1
In the [Setup] screen, select [Advanced
Settings].
2
Select [RF Mode Settings].
The [RF Mode Settings] screen
appears.
3
Select [Wide Band] or [Narrow Band].
When the configuration is complete,
the main screen appears again.
RF mode Transmitting
channel
number Description
Wide Band
(WIDE) 1/2/3/4/5/6 This mode
reduces any
interference
to other
wireless
equipment.
Narrow
Band
(NARROW) a/b/c/d/e/f This mode
uses the
Clear
Channel
Scan
function,
making it
useful for
avoiding
any
interference
from other
wireless
equipment.
Caution