Sony DWR-R02DN, Operating Instructions Manual, Page: 31 / 42

31
Changing the Settings on
the Transmitter
For details on menu operation, see “Basic Menu
Operations” on page 23.
You can change the settings on the transmitter that is
paired with this receiver using the GP/CH indication
(see
page 24) of the RECEIVER menu or TRANSMITTER
menu (see page 26) .
Before changing the settings, be sure to set pairing
configurations in the RF REMOTE menu and enable the
wireless remote control function by setting RF REMOTE
to ON.
The following shows the US model display.
Frequency band setting
(BAND)
Set this setting in the BAND screen of the RECEIVER
menu.
For details, see “Selecting the Frequency Band” on
page 19.
Group/channel Setting
(GP/CH)
Only this setting is set through the GP/CH indication of the
RECEIVER menu.
For details, see “Selecting the Group/Channel” on
page 19.
Transmitter Name Setting
(NAME)
Sets the name of the transmitter.
Power-saving Setting
(POWER SAVE)
To conserve power, this setting allows you to change the
transmitter to sleep mode using the wireless remote control
function.
When the setting of the transmitter is changed to sleep
mode, the signal for audio transmission is stopped and the
metadata is also no longer transmitted. For this reason,
“NO DATA” appears for all items in the TRANSMITTER
menu, except for “SLEEP” in the POWER SAVE
indication.
Transmission Power Setting
(RF POWER)
You can change the transmission power of the transmitter.
Audio Input Level Setting
(INPUT LEVEL)
Allows you to change the transmitter’s audio input level
setting.
This function may not be supported by some transmitters.
Attenuator Setting
(ATT)
Change the attenuator value when the audio input level
setting of the transmitter is set to MIC.
The attenuator values that can be selected depend on the
transmitter function.
Low-cut Filter Setting
(LCF)
The low-cut filter setting of the transmitter can be changed.
The frequency selection depends on the transmitter
function.
+48 V Power Setting
(+48V)
The +48 V power on the transmitter can be turned on or off.
This function may not be supported depending on the
transmitter.
Resetting Accumulated Transmitter
Use Time
(TIME)
The accumulated use time of the transmitter can be reset.
Audio codec mode setting
(CODEC
MODE)
Set the audio codec mode.
Transmitter
Receiver
Note
Note
Note
Note
Note