30
Setting Menus
Locking the POWER
Switch
(POWER SW LOCK)
The POWER switch can be locked to
prevent the microphone from being
accidentally turned off or on.
Even when the POWER switch is locked,
all parts of the microphone other than the
POWER switch remain functional.
UNLOCK:
The POWER switch is not
locked.
LOCK:
The POWER switch is locked.
When LOCK is selected, the POWER
switch lock icon appears in the display.
Wireless Remote Control
Function
(RF REMOTE)
This function must be set to allow the
wireless remote control function to be used
between the microphone and receiver.
OFF:
Stops the wireless remote control
function.
ON:
Starts the wireless remote control
function with the previously paired
receiver.
PAIRING:
Executes a new pairing.
For details, see “Pairing With a Receiver” on
page 20.
Setting the Brightness of
the Display
(BRIGHTNESS)
Ten levels of brightness can be selected for
the organic light-emitting diode display.
The selectable settings are the following:
(Dark)
1 2 3 4 5 6 7 8 9 10
(Bright)
Automatic Dimming of the
Display
(DIMMER MODE)
The organic light-emitting diode display
can be set to dim or turn off after a certain
amount of time.
AUTO OFF:
The display turns off after 30
seconds. The display goes on again when
you press the SET, +, or – button.
AUTO DIMMER:
The display dims after
30 seconds. The display becomes bright
again when you press the SET, +, or –
button.
ALWAYS ON:
The display stays on at the
brightness level set with the BRIGHTNESS
function.
Resetting Parameters to
Their Factory Settings
(FACTORY PRESET)
All parameter settings can be returned to
their factory settings.
Holding down the SET button until a
message appears asking for confirmation.
Press the + or – button repeatedly to select
YES, and then press the SET button to
enter. The microphone parameters are reset
to their factory settings.
• The setting for this function cannot be
changed during actual signal
transmission. To change the setting, turn
off the power first. Then while holding
down the SET button, turn the power on.
Then change the setting after the signal
transmission has stopped.
• To start signal transmission with the
factory parameter settings, turn off the
power and then turn it on again.
Notes
Summary of Contents for DWM-01
Page 39: ...Sony Corporation ...
