Sony DVS-9000, User Manual

Page: 95 / 1228

95
Names and Functions of Parts of the Control Panel
Chap
te
r
2
Men
u
s
and Con
tro
l
P
a
nel
• While this button is held down, you
can select a key source with the
cross-point buttons for the key bus.
• If you press this button twice in rapid
succession, the key bus selection
button [KEY3] in the cross-point
control block lights, and a key 3 key
bus cross-point can be selected.
• If you press this button, while
holding down [TRANS RATE]
button in the numeric keypad control
block, you can set the independent
key transition rate on the control
block.
b
Independent key transition
execution section
KEY3 ON button: This inserts or deletes
key 3 instantaneously. When key 3 is
present in the final program output
from the switcher, this lights red, and
otherwise lights amber.
TAKE button: This carries out an auto
transition on key 3.
c
K-SS (key snapshot) button
This enables key snapshot mode. In key
snapshot mode, it is possible to save and
recall key snapshots.
d
Key source name display/key
snapshot buttons
These show the signal name of the key fill
selected for key 3 and the transition rate on
two buttons. In key snapshot mode, these
correspond to registers 1 and 2 for key 3;
press to save or recall a key snapshot.
To save a key snapshot, with the [K-SS]
button lit amber, hold down [SHIFT] button
and press one of the key snapshot buttons.
This saves a key snapshot in the button you
pressed, which lights yellow.