Sony DVS-9000, User Manual

Page: 897 / 1228

897
Macro Attachment Assigning
Chap
te
r 1
6
Mac
ros
Executing a Macro by Macro Attachment
Note
For execution on any of the M/E and PGM/PST banks, use the [MCRO
ATTCH ENBL] button in the cross-point control block. To execute a macro
according to a macro attachment set elsewhere, assign “MCRO ATTCH
ENBL” to a utility/shotbox control block or user preference button, then use
that button.
Executing a macro assigned to a button
1
Depending on the location of the button you want to use, press the [MCRO
ATTCH ENBL] button, turning it on.
2
Press the desired button for which a macro attachment has been set.
This recalls the macro register assigned to the button, and the macro is
executed as follows, according to the operation mode.
Pre macro mode: The macro is executed first, and then the button
function is executed.
Post macro mode: The button function is executed first, and then the
macro is executed.
Macro only mode: The button function is not executed, and the macro
only is executed.
During macro execution, the button you pressed flashes.
Notes
• It is not possible to execute more than one macro at a time. Therefore, even
if you simultaneously press multiple buttons for which macro attachments
are set, only one macro is executed.
• During macro execution, recalling the same register again stops the macro
being executed. Therefore, pressing twice a button for which a macro
attachment is set stops the macro being executed.
• Individual events stored in a macro are executed according to the settings in
setup. If you change the settings in setup, a saved macro may not have the
expected effect.
• During macro execution, if you switch the control panel to macro editing
mode, the macro being executed stops.
Knob Parameter Adjustment Setting values
1 No Macro attachment settings scrolling 1 and upwards