Sony DVS-9000, User Manual

Page: 847 / 1228

847
Macros
Chap
te
r 1
6
Mac
ros
Macro Execution
To execute a macro, recall the register in which the macro is held.
Simultaneous with the register recall, all events stored in the macro are played
back (executed) in sequence without pause.
Pausing and restarting macro execution
It is also possible to execute a macro in the following ways.
Pause event
To adjust the execution timing of a particular event (to delay the start of
execution of the event by a particular time interval), you can store a special
event which pauses macro execution. This event is called a “pause event.”
When you store a pause event, you can set the interval for which the macro is
paused (the pause length) to any value in the range 1 to 999 frames. When the
set time has elapsed, the macro is automatically executed.
Pause zero event
By including a pause event with the time set to zero, you can make macro
execution pause at the pause event.
Step execution (requires a Setup menu setting)
By selecting step execution mode in the Setup menu, you can make macro
execution pause every time an event is executed.
Take operation
When a paused macro is restarted, this is referred to as a “Take” operation.
Macro take operation using a GPI input
You can carry out a macro take operation using a GPI input on the control panel
and DCU.
For GPI input settings, see “Interfacing With External Devices (Device
Interface Menu” in Chapter 19 (Volume 3) and “GPI Input Setting (GPI Input
Assign Menu)” in Chapter 22 (Volume 3).