Sony DVS-9000, User Manual

Page: 79 / 1228

79
Names and Functions of Parts of the Control Panel
Chap
te
r
2
Men
u
s
and Con
tro
l
P
a
nel
b
Region selection buttons
These select the functional block (“region”)
of the control panel to which operations
apply.
You can select more than one region at the
same time.
The first button you press is taken as the
reference region, and lights green, while the
next pressed button lights amber.
With the exception of the [MASTER] and
[ALL] buttons, you can change the region
assignment to the buttons as desired in the
Setup menu.
MASTR: Press this, turning it on, to save
region information in a master
snapshot register or master timeline
register, or to recall such region
information.
ALL: Select all regions. When any region
is already selected, pressing this button
makes all regions unselected.
M/E 1 to M/E 3, P/P: Select the
corresponding regions, M/E-1, M/E-2,
M/E-3, and PGM/PST.
USER 1 to USER 8: Select a User region.
P-Bus: Select the P-Bus region.
GPI: Select the GPI region.
RTR: Select the router region.
DEV1 to DEV12: Select the Device 1 to
Device 12 regions respectively.
MCRO: Select the macro region.
c
Function selection buttons
UNDO: After recalling a register, press this
button to return to the state before
recalling the register.
STORE STATS (store status): This lights
amber when data is stored in a register.
After saving data to a register, hold
down this button and press the
[UNDO] button to return the register to
the state before the data was saved.
TC (timecode): Press this button, turning it
on, to switch transition rate entry to the
timecode entry mode.
STORE: Press this button to switch to the
mode for saving a snapshot, effect,
shotbox or macro in a register.
RCALL (recall): Press this button to
switch to the mode for recalling a
snapshot, effect, shotbox or macro
from a register.
[STORE] button or [RCALL] button
flashes amber when one or more of the
regions assigned to the Region selection
buttons are not selected by the Region
Select menu.
d
Numeric keypad
In addition to the buttons for numeric input,
this includes buttons for adding attributes to
snapshots.
0 to 9: Used to input numeric digits.
. (period): Enters the decimal point.
When the [TRANS RATE] button is lit,
enters “00.” When the [EFF] button,
[SNAPSHOT] button or [SHOTBOX]
button is lit, this is used to find an
empty register.
+/–/ EFF DISS (effect dissolve): Invert the
sign, negative or positive.
When the [SNAPSHOT] button is lit,
applies the effect dissolve attribute to a
snapshot.
CLR/AUTO TRANS (clear/auto
transition): Clear an input value,
returning to the previous state.
When the [SNAPSHOT] button is lit,
applies the auto transition attribute to a
snapshot.
TRIM/GPI ENBL (enable): After
entering a difference value to be added
to an existing setting, press this button
to confirm the change.
ENTER: Confirm an entered value.
e
Display
This shows the selected region name and
entered numeric values.