41
Playback
R and P lit at same time:
Output signals are selected by
the R and P buttons in the PANEL SELECT section.
Recording signals are output when the R button is lit,
and playback signals are output when the P button is
lit.
If the REMOTE I/F menu item
9PIN(DUAL), output signals can also be switched from
the device connected to the REMOTE OUT(P) connector.
To switch the time data display
Time data shown in the time counter display and output
from the SUPER connector can be either the data
contained in recording signals or the data in playback
signals. You can select recording or playback data with the
R and P buttons in the PANEL SELECT section.
To select recording signal time data:
Press the R button.
To select playback signal time data:
Press the P button.
R is displayed before the data in the time counter display
when recording data is being output, and P is displayed
before the data when playback data is being output.
However, when the line output is playback data (the P
indicator in the LINE OUT SELECT section is lit) and
recording data is being displayed in the time counter
display (the R button is lit), R* is displayed before the data
in the time counter display. P* is displayed before the data
in the time counter display when line output is recording
data (the R indicator in the LINE OUT SELECT section is
lit) and playback data is being displayed in the time
counter display (the P button is lit).
To exit simultaneous recording and playback
mode
With the R or P button lit in the PANEL SELECT section,
press the STOP button to stop recording or playback. Press
the R and P buttons so that both buttons go out.
Note
You cannot exit simultaneous recording and playback
mode while performing simultaneous recording and
playback. Press the STOP button to stop recording or
playback. You can then exit the mode by pressing the
buttons in the PANEL SELECT section so that the buttons
go out.
Setting Points A and B for Repeat
Playback
You can conduct repeat playback of certain sections.
You can set the repeat playback start point (point A) and
end point (point B) by using the current position or
inputting time code values.
To perform repeat playback after setting points A and B,
press the PLAY button when the REMOTE indicator is
off.
Note
When performing repeat playback using points A and B as
the playback start and end points, make sure that the
REPEAT TOP and REPEAT END menu items
are set to A POINT and B POINT, respectively.
Inputting time code values for points A and
B
Using the following procedure, you can modify the time
code value for point A or B.
1
Press the MENU button.
The following menu display appears.
2
With “SETUP MENU” selected, press the
k
(OUT)
button.
The display changes as follows.
MENU RESET
SET
CUE
IN
OUT
5,7,9,12
13
12
8,11
1,15
2,3,4,6,
10,11
Setup menu
SYSTEM MENU
SETUP MENU
TC PRESET
DISK MENU
NETWORK MENU
DATE/TIME PRESET
HOURS METER
Monitor screen
Time counter display
Summary of Contents for DSR-DR1000P
Page 10: ...10 ...
Page 28: ...28 Location and Function of Parts ...
