85
Addi
tion
al
I
n
fo
rm
at
io
n
About care and storage of the lens
• Wipe the surface of the lens clean with a soft
cloth in the following instances:
– When there are fingerprints on the lens
surface.
– In hot or humid locations
– When the lens is exposed to salty air such as
at the seaside.
• Store in a well-ventilated location subject to
little dirt or dust.
• To prevent mold, periodically clean the lens as
described above. It is recommended that you
operate your camcorder about once a month to
keep it in optimum state for a long time.
To remove dust from inside the
viewfinder
1
Pull out the viewfinder.
2
While pushing in the tab on the side
with a fine-tipped implement such as a
ball point pen, pull the eyecup block in
the direction of the arrow to remove.
3
Remove dust from the eyecup block
with a camera blower, etc.
4
Press the viewfinder onto the body of
the camcorder.
5
Remove dust from the inside area where
the eyecup block was attached with a
camera blower, etc.
6
Attach the eyecup block to the
viewfinder, pushing it straight on until it
clicks.
b
Notes
• The eyecup block is a precision part. Do not
disassemble it further.
• Do not touch the lens of the eyecup block.
On charging the pre-installed
rechargeable battery
Your camcorder has a pre-installed
rechargeable battery to retain the date, time,
and other settings even when the POWER
switch is set to OFF (CHG). The pre-
installed rechargeable battery is always
charged while your camcorder is connected
to the wall outlet via the AC Adaptor or
while the battery pack is attached. The
rechargeable battery will be fully
discharged in about
3 months
if you do
not use your camcorder at all without the
Tab
Continued
,
