1-2E
DSC-F828
Note :
The error code is cleared if the battery is removed, except defective flash unit.
*1: The error display is given in two ways.
Display Code
C:32:01
C:13:01
E:91:01
E:61:00 *1
E:61:10 *1
Countermeasure
Turn off the main power then back on.
Replace the memory stick.
Format the memory stick with the DSC-F828.
Checking of flash unit or replacement of
flash unit.
Checking of lens drive circuit
Cause
Trouble with hardware.
• The type of memory stick that cannot be
used by this machine, is inserted.
• Data is damaged.
• Unformatted memory stick is inserted.
Abnormality when flash is being
charged.
When failed in the focus initialization.
Caution Display During Error
SYSTEM ERROR
MEDIA ERROR
Flash LED
Flash display
Flashing at 3.2 Hz
—
Self-diagnosis display
• C:
ss
:
ss
The contents which can be handled
by customer, are displayed.
• E:
ss
:
ss
The contents which can be handled
by engineer, are displayed.
1-4. DESCRIPTION ON SELF-DIAGNOSIS DISPLAY
1-3. NOTES ON HANDLING THE LASER DIODE [LASER UNIT]
The laser diode may suffer electrostatic breakdown because of the
potential difference generated by the charged electrostatic load, etc.
on clothing and the human body.
During repair, pay attention to electrostatic breakdown and also use
the procedure in the printed matter which is included in the repair
parts.
The flexible board is easily damaged and should be handled with
care.
Laser unit
(D001)
Soldering Conditions of Laser Unit
Temperature of
Less than 350
°
C
the Soldering Iron
Time to Solder
3 seconds
Interval to Solder
Next terminal is soldered after waiting
for 1 second
Note:
Adjustment is needed when laser unit is replaced.
Refer to “21. AF Laser Output Adjustment” (page6-29) and “22.
AF Laser Axis Check” (page6-30) of SERVICE MANUAL, ADJ
(987627951.pdf).
