33
Replacing the Lamp
M
a
in
te
na
nc
e
5
Insert the new lamp all the way in until
it is securely in place (
a
). Tighten the
two screws (
c
). Fold down the handle
to replace it (
b
).
• Be careful not to touch the glass surface
of the lamp.
• The power will not turn on if the lamp is
not secured properly.
6
Close the lamp cover and tighten the
three screws.
Be sure to attach the lamp cover securely
as it was. If not, the projector cannot be
turned on.
7
Turn the projector back over.
8
Connect the power cord.
The ON/STANDBY indicator around
the
?
/
1
key lights in red.
9
Press the following keys on the
Remote Commander in the following
order for less than five seconds each:
RESET,
b
,
B
, ENTER.
Do not put your hands into the lamp
replacement slot, and do not allow any liquid or
other objects into the slot
to avoid electrical
shock or fire.
Disposal of the used lamp
For the customers in the USA
This product contains mercury. Disposal of
this product may be regulated if sold in the
United States. For disposal or recycling
information, please contact your local
authorities or the Electronics Industries
Alliance (http://www.eiae.org).
Notes
Note
Fold down the
handle.
Caution
