![background image](http://html.mh-extra.com/html/sony/cmt-nez7dab/cmt-nez7dab_operating-instructions-manual_420428013.webp)
T
uner
13
GB
Before you can receive DAB, you must register
the contents of broadcasts (service components)
so that they can be received by the DAB tuner
using the DAB Automatic Scan procedure.
DAB Automatic Scan
DAB Automatic Scan starts automatically only
when you turn on the system for the first time
after you purchase the system.
If you want to use the DAB Automatic Scan
again, perform the procedure below.
1
Press DAB AUTO SCAN on the unit.
“DAB Auto Scan? Push DAB” appears.
2
Press DAB on the unit.
Scanning begins. “DAB Auto Scan”
appears. Depending on the DAB services
available in your area, scanning may take a
few minutes.
When scanning is complete, available
service component list is created.
Notes
• If your country or region does not support DAB
broadcast, “No Service” appears.
• Do not press any button on the unit or supplied
remote during DAB Automatic Scan. Scanning is
interrupted and service component list may not be
created properly. In this case, perform the DAB
Automatic Scan again.
• If you move to another area, repeat this procedure to
store the stations for your new area.
• This procedure clears all previously stored presets.
• This procedure does not create any presets.
To move system location
When you wish to move the system to a new
location, to preserve your own DAB settings,
make sure the clock display* appears when the
system is powered down, before unplugging the
mains lead and DAB lead aerial.
* In Power Saving Mode, make sure the clock display
disappears.
You can preset up to 20 DAB stations, 20 FM
stations and 10 AM stations. You can then tune
in any of those stations simply by selecting the
corresponding preset number.
Automatic tuning preset
You can automatically tune in all of the service
components or stations that can be received in
your area and then store them.
1
Press TUNER/BAND (or FUNCTION
repeatedly) to switch the function to
TUNER.
2
Press TUNER/BAND repeatedly to
select “DAB”, “FM” or “AM”.
You can also use the DAB button to select
DAB directly.
3
Press TUNING MODE repeatedly until
“AUTO” appears in the display.
4
Press + or – (or or – on the
unit).
Service component list is played downward
(DAB) or the frequency changes as the
system scans for a station (FM/AM).
Scanning stops automatically when a
station is tuned in. At that time, “TUNED”
and “STEREO” (for stereo program only)
appear.
If “TUNED” does not appear and the
scanning does not stop
Set the frequency of the desired radio
station as described in steps 3 and 4 of
“Manual tuning preset (FM/AM bands
only)” (page 14).
Manual tuning is not available for DAB.
Tuner
Scanning DAB stations
Presetting radio stations
continued
Summary of Contents for CMT-NEZ7DAB
Page 35: ......