Sony CDX-M800, Service Manual

Page: 24 / 56

24 24
CDX-M800
tuner unit
(TUX501)
IN SELF SW board
SWITCH board
LOAD SW board
DISPLAY board
SERVO board
SL SW board
MAIN board
SUB board
4-5. CIRCUIT BOARDS LOCATION
• Waveforms
— Servo Board —
(MODE: CD PLAY)
1
2Vp-p
2
3.2msec
IC1
ts (PACK)
3
IC1 uj
(RFO)
4
Approx. 100mVp-p
IC1 oa (FEO)
0V
5
Approx. 100mVp-p
IC1
od (TEO)
16.9344MHz
IC1 wd (XTAL)
5Vp-p
1.2Vp-p
0V
• Waveforms
—
Main Board
—
(MODE: FM)
1
3.2Vp-p
2
32.768kHz
IC303
9 (XOUT)
3
6MHz
IC303 qa (OSCOUT)
4.3MHz
IC502 4 (OSCD)
1.8Vp-p
3.6Vp-p
1
30MHz
IC2
qa (XOUT)
1.5Vp-p
• Waveform
—
Display Board
—
(MODE: FM)
Note:
The components identi-
fied by mark
0
or dotted
line with mark
0
are criti-
cal for safety.
Replace only with part
number specified.
Note:
Les composants identifiés par
une marque
0 sont critiques
pour la sécurité.
Ne les remplacer que par une
piéce portant le numéro
spécifié.
THIS NOTE IS COMMON FOR PRINTED WIRING
BOARDS AND SCHEMATIC DIAGRAMS.
(In addition to this, the necessary note is
printed in each block.)
for schematic diagram:
• All capacitors are in µF unless otherwise noted. pF: µµF
50 WV or less are not indicated except for electrolytics
and tantalums.
• All resistors are in Ω and 1 /
4
W or less unless otherwise
specified.
• % : indicates tolerance.
•
f
: internal component.
• C : panel designation.
• A : B+ Line.
• Power voltage is dc 14.4V and fed with regulated dc power
supply from ACC and BATT cords.
• Voltages are taken with a VOM (Input impedance 10 M
Ω
).
Voltage variations may be noted due to normal produc-
tion tolerances.
• Waveforms are taken with a oscilloscope.
Voltage variations may be noted due to normal produc-
tion tolerances.
• Circled numbers refer to waveforms.
• Signal path.
F
: FM
f
: AM/MW/LW
J : CD
• Abbreviation
CND : Canadian model
for printed wiring boards:
• X : parts extracted from the component side.
• Y : parts extracted from the conductor side.
•
x
: parts mounted on the conductor side.
• a : Through hole.
•
: Pattern from the side which enables seeing.
(The other layer’s patterns are not indicated.)
Caution:
Pattern face side: Parts on the pattern face side seen from the
(Side B)
pattern face are indicated.
Parts face side: Parts on the parts face side seen from the
(Side A)
parts face are indicated.
• Abbreviation
CND : Canadian model