15
*1 When the unit is turned off.
*2 When the tuner is selected.
*3 When the CD or USB is selected.
SOUND:
AUTO OFF
Shuts off automatically after a desired
time when the unit is turned off: “NO,”
“30S (Seconds),” “30M (Minutes),” “60M
(Minutes).”
AUX-A
*
1
(AUX Audio)
Activates the AUX source display: “ON,”
“OFF” (page 17).
REAR/SUB
*
1
Switches the audio output: “SUB-OUT”
(subwoofer), “REAR-OUT” (power
amplifier).
CT
(Clock Time)
Activates the CT function: “ON,” “OFF”
(page 8).
BTM
*
2
ZAPPIN
*
3
ZAP TIME
(Zappin Time)
Selects the playback time for the
ZAPPIN function.
– “Z.TIME-1 (about 6 seconds),”
“Z.TIME-2 (about 15 seconds),”
“Z.TIME-3 (about 30 seconds).”
ZAP BEEP
(Zappin Beep)
Applies a beep sound between track
passages: “ON,” “OFF.”
EQ7 PRESET
EQ7 SETTING
POSITION
SET F/R POS
(Set Front/Rear Position)
ADJ POSITION
*
1
(Adjust Position)
SET SW POS
*
1
*
2
(Set Subwoofer
Position) (page 13)
BALANCE
Adjusts the sound balance: “RIGHT-15”
– “CENTER” – “LEFT-15.”
FADER
Adjusts the relative level: “FRONT-15” –
“CENTER” – “REAR-15.”
DM+
*
3
LOUDNESS
(Dynamic Loudness)
Reinforces bass and treble for clear
sound at low volume levels: “ON,”
“OFF.”
ALO
(Automatic Level Optimizer)
Adjust the playback volume level of all
playback sources to the optimum level:
“ON,” “OFF.”
RB ENH
*
4
(Rear Bass Enhancer)
RBE MODE
(Rear Bass Enhancer
Mode)
Selects the rear bass enhancer mode: “1,”
“2,” “3,” “OFF.”
LPF FREQ
(Low Pass Filter Frequency)
Selects the subwoofer cut-off frequency:
“50Hz,” “60Hz,” “80Hz,” “100Hz,”
“120Hz.”
LPF SLOP
(Low Pass Filter Slope)
Selects the LPF slope: “1,” “2,” “3.”
SW DIREC
*
5
(Subwoofer Direct
Connection)
SW MODE
(Subwoofer Mode)
Selects the subwoofer mode: “1,” “2,” “3,”
“OFF.”
SW PHASE
(Subwoofer Phase)
Selects the subwoofer phase: “NORM,”
“REV.”
SW POS
*
1
(Subwoofer Position)
(page 13)
Selects the subwoofer position: “NEAR,”
“NORMAL,” “FAR. ”
LPF FREQ
(Low Pass Filter Frequency)
Selects the subwoofer cut-off frequency:
“50Hz,” “60Hz,” 80Hz,” “100Hz,”
“120Hz.”
LPF SLOP
(Low Pass Filter Slope)
Selects the LPF slope: “1,” “2,” “3.”