4
Getting Started
Resetting the unit
Before operating the unit for the first time, or
after replacing the car battery or changing the
connections, you must reset the unit.
Detach the front panel and press the RESET
button with a pointed object, such as a ballpoint
pen.
Note
Pressing the RESET button will erase the clock setting
and some stored contents.
Setting the clock
The clock uses a 12-hour digital indication.
1
Press and hold the select button.
The setup display appears.
2
Press the select button repeatedly
until “CLOCK-ADJ” appears.
3
Press
(DSPL)
.
The hour indication flashes.
4
Rotate the volume control dial to set
the hour and minute.
To move the digital indication, press
(DSPL)
.
5
Press the select button.
The setup is complete and the clock starts.
To display the clock, press
(DSPL)
. Press
(DSPL)
again to return to the previous display.
With the card remote commander
In step 4, to set the hour and minute, press
M
or
m
.
Detaching the front panel
You can detach the front panel of this unit to
prevent theft.
Caution alarm
If you turn the ignition switch to the OFF
position without detaching the front panel, the
caution alarm will sound for a few seconds.
The alarm will only sound if the built-in
amplifier is used.
1
Press
(OFF)
.
The unit is turned off.
2
Press
(OPEN)
.
The front panel is flipped down.
3
Slide the front panel to the right, then
gently pull out the left end of the front
panel.
Notes
•
Do not drop or put excessive pressure on the front
panel and display window.
•
Do not subject the front panel to heat/high
temperature or moisture. Avoid leaving it in a parked
car or on a dashboard/rear tray.
RESET
button
1
2
