Sony CDX-GT290, Operating Instructions Manual, Page: 8 / 56

8
Radio
Storing and receiving stations
Caution
When tuning in stations while driving, use Best
Tuning Memory (BTM) to prevent an accident.
Storing automatically — BTM
1
Press
(SOURCE/OFF)
repeatedly until
“TUNER” appears.
To change the band, press
(MODE)
repeatedly. You can select from FM1, FM2,
FM3, MW, SW1 or SW2.
2
Press and hold the select button.
The setup display appears.
3
Press the select button repeatedly
until “BTM” appears.
4
Press (SEEK) +.
The unit stores stations in order of frequency
on the number buttons.
A beep sounds when the setting is stored.
Storing manually
1
While receiving the station that you
want to store, press and hold a
number button (
(1)
to
(6)
) until
“MEMORY” appears.
Note
If you try to store another station on the same number
button, the previously stored station will be replaced.
Receiving the stored stations
1
Select the band, then press a number
button (
(1)
to
(6)
).
Tuning automatically
1
Select the band, then press (SEEK) +/–
to search for the station.
Scanning stops when the unit receives a
station. Repeat this procedure until the
desired station is received.
Tip
If you know the frequency of the station you want to
listen to, press and hold
(SEEK)
+/ – to locate the
approximate frequency, then press
(SEEK)
+/ –
repeatedly to fine adjust to the desired frequency
(manual tuning).