Sony CDX-A360, Service Manual

Page: 5 / 48

5
CDX-A360
SECTION 2
GENERAL
• LOCATION OF CONTROLS AND BASIC OPERATIONS
• CONNECTIONS
This section is extracted
from instruction manual.
6
Location of controls and basic operations
Main unit
Card remote commander
RM-X151 Refer to the pages listed for details. The
corresponding buttons on the card remote
commander control the same functions as those
on the unit.
A OFF button
To power off; stop the source.
B
Number buttons
CD:
(1) / (2) : GP * 1 /ALBM * 2 –/+
To skip groups/albums (press); skip
groups/albums continuously (press and
hold).
(3) : REP 8
(4) :
SHUF 8
(6) : PAUSE
To pause playback. To cancel, press
again.
Radio:
To receive stored stations (press); store
stations (press and hold).
C
AF (Alternative Frequencies)/TA
(Traffic Announcement) button
9
To set AF and TA in RDS.
D
PTY (Program Type) button 10
To select PTY in RDS.
CDX-A360
OFF
DSPL SCRL
SEL SOURCE MODE
1 3 2
4 6 5
ATT
VOL
+
–
+
–
7
E
SEEK –/+ buttons
CD:
To skip tracks (press); skip tracks
continuously (press, then press again within
about 1 second and hold); reverse/fast-
forward a track (press and hold).
Radio:
To tune in stations automatically (press); find
a station manually (press and hold).
F Disc slot
To insert the disc (label side up). Playback
starts automatically.
G Z (eject) button
To eject the disc.
H
(front panel release) button 5
I
AUX input jack 12
To connect a portable audio device.
J Receptor for the card remote
commander
K
RESET button (located behind the front
panel) 4
L
SENS/BTM button
To improve weak reception: LOCAL/MONO
(press); start the BTM function (press and
hold).
M
EQ3 (equalizer) button 11
To select an equalizer type (XPLOD,
VOCAL, CLUB, JAZZ, NEW AGE, ROCK,
CUSTOM or OFF).
N
SOURCE button
To power on; change the source (Radio/CD/
AUX).
O
Volume control dial/select button 11
To adjust volume (rotate); select setup items
(press and rotate).
P MODE button 8
To select the radio band (FM/MW/LW).
Q
DSPL (display)/DIM (dimmer) button
5, 8
To change display items (press); change the
display brightness (press and hold).
R
Display window
The following buttons on the card remote
commander have also different buttons/functions
from the unit. Remove the insulation film before
use (page 4).
ql
< ( . )/ , ( > ) buttons
To control CD/radio, the same as (SEEK)
–/+ on the unit.
w;
VOL (volume) +/– button
To adjust volume.
wa
ATT (attenuate) button
To attenuate the sound. To cancel, press
again.
ws
SEL (select) button
To select items.
wd M (+)/ m (–) buttons
To control CD, the same as (1) / (2) –/+ on
the unit.
wf
SCRL (scroll) button 8
To scroll the display item.
wg
Number buttons
To receive stored stations (press); store
stations (press and hold).
*1
When an ATRAC CD is played.
*2 When an MP3/WMA is played.
Note
If the unit is turned off and the display disappears, it
cannot be operated with the card remote commander
unless
(SOURCE) on the unit is pressed, or a disc is
inserted to activate the unit first.
Tip
For details on how to replace the battery, see
“Replacing the lithium battery of the card remote
commander” on page 14.
* AUDIO OUT SUB/REAR
Voorbeeldaansluitingen
Opmerkingen
• Sluit eerst de aarddraad aan voordat u de versterker aansluit.
• U hoort de waarschuwingstoon alleen als de ingebouwde
versterker wordt gebruikt.
Exemple de raccordement
Remarques
• Raccordez d’abord le câble de mise à la masse avant de
connecter l’amplifi cateur.
• L’alar me est émise uniquement lorsque l’amplifi cateur intégré
est utilisé.
Anschlussbeispiel
Hinweise
• Schließen Sie unbedingt zuerst das Massekabel an, bevor Sie
den Verstärker anschließen.
• Der Alarm ist nur zu hören, wenn der integrierte Verstärker
verwendet wird.
Esempio di collegamento
Note
• Assicurarsi di collegare il cavo di messa a terra prima di
collegare l’apparecchio all’amplifi catore.
• L’allarme viene emesso solo se si utilizza l’amplifi catore
incorporato.
Connection example
Notes
• Be sure to connect the ground (earth) lead before connecting
the amplifi er.
• The alarm will only sound if the built-in amplifi er is used.