24
CDP-M400CS
A B C D E F G
ADJ Mode
1. Turn ON the power of the unit, set disc to disc table, and
perform chucking.
2. Disconnect the power supply plug from the outlet.
3. To set ADJ mode, connect the test point (ADJ) of the MAIN
board to Ground, and connect the power supply plug to the
outlet.
In this mode, table rotation and loading operations are not performed
because it is taken that the disc has already been chucked.
Note: The same operations are also performed in the following
when the test point (ADJ) is connected to Ground after turning
on the power.
•
Direct search (movement of sledding motor) is not performed
during accessing
•
Ignored even when GFS becomes L
•
Ignored even when the Q data cannot be read
•
Focus gain does not decrease
Key and Display Check Mode
To set this mode, connect the test point (AFADJ) on the MAIN
board to Ground, and connect the power supply plug to the outlet.
Note: When this mode is executed, all title memos recorded will
be erased.
•
When this button is pressed, “line # No. #” will be displayed.
However, these will not be displayed for the following special
buttons. However, these will not be displayed for the following
special buttons.
x
(stop) button: FL segment check
(Refer to FL Tube Check Patterns)
P
(pause) button: FL grid check
(Refer to FL Tube Check Patterns)
The
P
LED also lights up simultaneously.
·
(play) button: All FL segment and grid will light up.
·
LED also lights up simultaneously.
TIMER switch: When the switch position is PLAY , the
STANDBY LED lights up. It goes OFF when
set to OFF .
Each time this button is pressed, the value of the “Got ## keys”
increases. Buttons pressed once will not be counted when pressed
again.
FL Tube Check Patterns
Segment check
Grid check
•
When the jog dial and AMS is rotated to the right, the TOP
ARTIST LEDs light up in the order of 8
n
7..1
n
HISTORY
ALBUM SELECT
n
MEGA CONTROL
n
X
n
H
n
ARTIST MODE
n
8.
•
When the jog dial and AMS is rotated to the left, the TOP
ARTIST LEDs light up in the order of 1
n
2..8
n
ARTIST
MODE
n
H
n
X
n
MEGA CONTROL ALBUM
SELECT
n
HISTORY
n
1.
•
Abbreviation
FL: Fluorescent Indicator Tube
To end the ADJ mode
1. Disconnect the plug.
2. Remove the wire between AFADJ and GND.
Adjustment Location: MAIN board (See page 28)
To end the ADJ mode
1. Press the
1/u
button and disconnect the plug.
2. Remove the wire between ADJ and GND.
Magnified
Summary of Contents for CDP-M400CS Operating Instructions (CDPM400CS)
Page 69: ...69 CDP M400CS MEMO ...
