Playing CDs
12
EN
Where purchased␣
Europe and Singapore
Canada
Other countries
Additional Information
Specifications
Compact disc player
Laser
Semiconductor laser (
λ
= 780 nm)
Emission duration: continuous
Laser output
Max 44.6
µ
W*
* This output is the value measured at
a distance of 200 mm from the
objective lens surface on the Optical
Pick-up block with 7 mm aperture.
Frequency response
2 Hz to 20 kHz ± 1.0 dB
Signal-to-noise ratio
More than 100dB
Dynamic range
More than 96dB
Harmonic distortion
Less than 0.01%
Channel separation
More than 86dB
LINE OUT
Jack
type
Phono
jacks
Load
impedance
Over 10 kilohms
Power requirements
220 V
–
230 V AC, 50/60 Hz
120 V AC, 60 Hz
110 V
– 120 V or 220 V – 240 V AC,
adjustable, 50/60 Hz
Output
Maximum
output
level
2 V
(at 50 kilohms)
General
Power requirements
Troubleshooting
If you experience any of the following difficulties while
using the player, use this troubleshooting guide to help
you remedy the problem. Should any problem persist,
consult your nearest Sony dealer.
There’s no sound.
/
Check that the player is connected securely.
/
Make sure you operate the amplifier correctly.
The CD does not play.
/
There’s no CD inside the player (“no dISC”
appears). Insert a CD.
/
Place the CD with the label side up on the disc
tray correctly.
/
Clean the CD (page 11).
/
Moisture has condensed inside the player.
Remove the disc and leave the player turned on
for about an hour (page 2).
The player functions incorrectly.
/
The microcomputer chips may be operating
incorrectly. Turn the power off, then turn it
back on to reset the player.
Power consumption
10 W
Dimensions (approx.)
430
×
135
×
400 mm
(w/h/d)
(17
×
5 3/8
×
15 3/4 in.) incl. projecting
parts
Mass (approx.)
4.5 kg (9 lbs 15 oz)
Supplied accessories
Audio cord (2 phono plugs – 2 phono plugs) (1)
Design and specifications are subject to change without notice.
