E:\JOB\3857686011CBKNC01SYE\02GB09C01-SY.fm
masterpage:Right
CBK-NC01
3-857-686-01 (1)
23
5
Press the MENU knob again, turn
the knob until the arrow cursor
points to “NETWORK/THUMB,”
and then press the knob.
6
Turn the MENU knob to change
“NETWORK/THUMB” setting to
“STBY,” and then press the knob.
7
Set the MENU ON/OFF switch to
OFF.
8
Restart the camcorder.
The new settings are applied when
the camcorder turns on.
If you cannot log in using FTP
If you cannot log in using FTP, do the
following:
• Make sure the procedures “Network
settings” and “FTP log-in settings”
were performed correctly.
• Make sure a disc is inserted into the
camcorder.
• Make sure the disc inside the
camcorder is stopped.
• Make sure the files/clips recorded on
the disc is not shown in thumbnail
images.
Appendix
Specifications
Applicable standards
IEEE 802.3 10BASE-T,
IEEE 802.3u 100BASE-
TX
Power consumption
0.5 W maximum (power
supplied by camcorder)
Connector
RJ-45
Dimensions
92 mm × 144 mm × 33
mm (3
5
/
8
in. × 5
3
/
4
in. ×
1
5
/
16
in.) (w/h/d)
Mass
105 g (4 oz)
Supplied accessory
Ferrite core (part No: 1-
400-061-11) (1)
Proxy Browsing
Software PDZ-1 (1)
Installation Manual (1)
Design and specifications are subject to
change without notice.
05 POWER SAVE
i.LINK OUT : DSABL
REC AUDIO OUT : EE
NETWORK/THUMB : STBY
TOP
