Sony CA-TX50, Operating Instructions Manual

Page: 77 / 194

Chapter 4 Viewfinder Screen Indications and Menus
52
Chapter 4 Viewfinder Screen Indications and Menus
PLAY TAPE NEAR END
RET1 TCG 12:34:56:00
ABCD1234 04 08 01
5600K 12:34:56PM
64ND SKIN W:A 36dB 100.4H
Z
:::::::: 30-25 F5.6
Viewfinder Normal Indications
During normal operation, the following items can be
indicated in the viewfinder.
The significance of each of the indications shown in
the figure is as follows.
1
VTR warning indication
This shows warning indications about operation or
status of the connected VTR.
When connecting the DSR-1/1P or PVV-3/3P
a) Displayed only when a DSR-1/1P is connected.
b) Displayed only when a PVV-3/3P is connected.
c) Whether or not to display can be selected by menu setting.
d) This is recorded over the picture being shot.
e) Displayed only when a CA-TX50/TX50P or CCU-TX50/TX50P is connected
a) Even if a VTR is not connected, LOW BATT is displayed
when the voltage of the power supply to the camera head
fall to or below 11.0 V.
OXIDE TAPE
(PVV-3/3P only)
1 VTR warning indication
a), b), c)
2
VTR operation status
indication
a), b), c)
3
Return video indication e)
5
Status display area
6 Camera ID indication
c)
7
5600K indication c)
8 Filter setting indication
c)
9 SKIN DTL indication
c)
0 White balance indication c)
qs Shutter setting indication
c)
qd
Audio recording level
indicators
a), b), c)
qf
Tape remaining indication a), b), c)
qg
Lens f-stop indication c)
qh
Clock indication c), d)
qa
Gain indication c)
Indication Meaning
NO TAPE There is no tape loaded.
REC INHIBIT
The tape is in the recording inhibited
state.
LOW BATT
a) The battery is almost exhausted.
BATT. END
The battery is exhausted.
TAPE NEAR END The tape is near the end.
TAPE END The tape is at the end.
CHECK REMOTE
(PVV-3/3P only) A device other than a remote control
unit (e.g. headphones) is connected to
the REMOTE connector.
SERVO
The servo lock has been lost.
There is condensation.
The video heads are clogged, or there
is some other fault in the recording
system.
Indication Meaning
HUMID
SLACK
An oxide tape has been loaded. (The
tape is automatically ejected.)
The tape is not wound properly.
RF
4 Time data indication
a), b), c)