C:\Users\CHAILING\Desktop\FULLSET_CLOVER\Group_Clover 22 (Rev-
1)\4537410112\4537410112\4537410112_US\US03STU.fm
KDL-60W630B/60W610B
4-537-410-
11
(2)
11
US
US
2
Fix the TV to the Table-Top Stand using
the supplied screws. The arrow marks
indicate the location of the screw
holes used for securing the Table-Top
Stand.
~
•
If using an electric screwdriver, set the
torque at approximately 1.5 N·m
{15 kgf·cm}.
To detach the Table-Top Stand from the TV,
remove the screws fixed in step 2.
~
•
Do not remove the Table-Top Stand for any
reason other than to install corresponding
accessories on the TV.
•
Be sure the TV is vertical before turning on.
To avoid uneven picture uniformity do not
power on the TV with the LCD panel facing
down.
•
When attaching the Table-Top Stand again,
be sure to fasten the screws (previously
removed) to the original holes on the rear of
the TV.
2: Connecting the TV
~
•
Use an antenna cable connector no greater
than 14 mm thick.
•
When connecting the cable to the Cable/
Antenna, input finger tighten only, over
tightening the connection can damage the
TV.
•
Before moving the TV, disconnect all of the
cables connected to the TV to prevent
damaging the TV when it is moved.
•
Use an HDMI cable connector within 12 mm
(thickness) × 21 mm (width).
•
For more information on connections, refer to
the i-Manual.
x
Shown with a Set Top Box with
HDMI connection
Detaching the Table-Top
Stand from the TV
x 2
Set Top Box
(Continued)
